你好，歡迎訪問濟南金昊化工有限公司！
專注品質,信賴服務
我們用心做產品服務
咨詢熱線：
13869119097
專注品質,信賴服務
我們用心做產品服務
咨詢熱線：
13869119097
順酐過程中的主要污染源及污染物是廢氣、廢水、廢渣等，在如何處理廢氣等方面作了以研究和分析:由于順酐過程中產生的廢氣如果直接排放會對人身體健康造成非常大的傷害，因此必須積極有效地進行處理。水吸收塔或有機溶劑吸收塔排放出的尾氣是順酐裝置的尾氣主要來源，在以苯為原料的路線上，廢氣處理系統的設計就是為了從吸收塔排出氣體中的有機
The main pollution sources and pollutants in the production process of maleic anhydride are exhaust gas, wastewater, waste residue, etc. Research and analysis have been conducted on how to treat exhaust gas. As the exhaust gas generated in the production process of maleic anhydride can cause significant harm to human health if discharged directly, it must be actively and effectively treated. The exhaust gas discharged from the water absorption tower or organic solvent absorption tower is the main source of exhaust gas in the production of maleic anhydride units. In the production route using benzene as raw material, the design of the exhaust gas treatment system is to remove organic matter from the exhaust gas from the absorption tower
物，如苯、二甲苯、CO等。
Substances such as benzene, xylene, CO, etc.
的方法是使有機物在催化劑的作用下與氧發生反應，使之變成水和二氧化碳。應根據尾氣中污染物的濃度、性質、條件和經濟性進行實施。以正丁烷制順酐尾氣處理為例，廢氣處理程序較為復雜，但卻有效節約能源。其工藝流程為:自吸收塔頂排出的廢氣中會
The method of removal is to cause organic matter to react with oxygen under the action of a catalyst, turning it into water and carbon dioxide. Implementation should be based on the concentration, nature, production conditions, and economic efficiency of pollutants in the exhaust gas. Taking the treatment of tail gas from n-butane to maleic anhydride as an example, the waste gas treatment process is relatively complex, but it effectively saves energy. The process flow is as follows: in the exhaust gas discharged from the top of the absorption tower
有大量CO、未反應的正丁烷和其他有機物及氧等，進入膜分離裝置，含正丁烷的氣體返回反應器，另一部分廢氣，即滲余氣則送入蓄熱式氧化器。燃氣加熱到790C，使有機物在高溫下發生氧化反應，運行后小再需外界燃料供應，廢氣自行氧化且生成的熱量產生2.5MPa蒸汽3.6t/h。氧化后的廢氣中的碳氫化合物以COz和水蒸氣的形式排放到大氣中。
A large amount of CO, unreacted n-butane, other organic compounds, and oxygen enter the membrane separation device, and the gas containing n-butane returns to the reactor. The other part of the exhaust gas, i.e. residual gas, is sent to the regenerative oxidation reactor. Heating the gas to 790C causes organic matter to undergo oxidation reaction at high temperatures. After operation, external fuel supply is required, and the exhaust gas oxidizes itself and generates 2.5MPa steam of 3.6t/h of heat. The hydrocarbons in the oxidized exhaust gas are discharged into the atmosphere in the form of COz and water vapor.
苯法順酐是在固定床反應器中，使原料苯經過催化劑V-M)-P碳化硅的催化，與空氣接觸完成氧化反應，生成順酐氣體。然后順酐氣體經水的吸收，以及恒沸脫水，減壓連續精餾后，得到順酐。苯法順酐的工藝中，通過對催化劑的裝填、反應器壓力、反應器進口氣溫度、空速和熔鹽溫度的優化來完善整個工藝。
The production of maleic anhydride by the benzene method is carried out in a fixed bed reactor, where the raw material benzene is catalyzed by the catalyst V-M) - P silicon carbide and comes into contact with air to complete the oxidation reaction, generating maleic anhydride gas. Then, the maleic anhydride gas is absorbed by water, followed by azeotropic dehydration and continuous distillation under reduced pressure to obtain maleic anhydride. In the production process of benzene based maleic anhydride, the entire process is improved by optimizing the loading of catalysts, reactor pressure, reactor inlet temperature, space velocity, and molten salt temperature.
本文由順酐廠家友情奉獻.更多有關的知識請點擊: http://m.gddxcpa.com 真誠的態度.為您提供為的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.
This article is a friendly contribution from maleic anhydride manufacturers. For more relevant knowledge, please click on: http://m.gddxcpa.com Sincere attitude. We will provide you with comprehensive services. We will gradually contribute more relevant knowledge to everyone. Stay tuned
